/NASA’s%20Artemis%20III%20Announcement%20(Official%20NASA%20Trailer)~thumb.jpg)
KENNEDY SPACE CENTER, FLA. -- In the Space Station Processing Facility, the P6 integrated truss segment is lowered into the payload transport canister under the watchful eyes of the worker inside the canister as well as the workers on the sides. After being s…
Ver en NASA ↗🚀 Biblioteca espacial oficial
Imágenes y vídeos de NASA
Explora el catálogo multimedia público de NASA sin salir de TuPortalNews.
Explora temas destacados
Selecciona un tema o realiza una búsqueda personalizada.
7.273 resultados en NASA
KENNEDY SPACE CENTER, FLA. -- On Launch Pad 39B, the payload transport canister, with the P6 integrated truss segment inside, is lifted toward the payload changeout room (PCR). The PCR is the enclosed, environmentally controlled portion of the Rotating Servic…
Ver en NASA ↗KENNEDY SPACE CENTER, FLA. -- In the Space Station Processing Facility at NASA's Kennedy Space Center, the integrated cargo carrier-lite, or ICC-L, is ready to be lifted and placed in the payload canister for mission STS-122. Joining the primary payload, th…
Ver en NASA ↗KENNEDY SPACE CENTER, Fla. -- At Launch Complex 17-A, Cape Canaveral Air Force Station, the Genesis spacecraft is lifted to the top of the launch tower. Genesis is 7.5 feet (2.3 meters) long and 6.6 feet (2 meters) wide, with a wingspan of solar array 26 feet…
Ver en NASA ↗KENNEDY SPACE CENTER, Fla. -- Fairing installation around the Genesis spacecraft is complete inside the mobile service tower at Launch Complex 17-A, Cape Canaveral Air Force Station. Genesis is 7.5 feet (2.3 meters) long and 6.6 feet (2 meters) wide, with a w…
Ver en NASA ↗In the Kennedy Space Center’s Press Site auditorium, on Friday, July 20, 2018, agency and mission leaders speak to members of the media during a prelaunch briefing for the Parker Solar Probe mission. From left are: Betsy Congdon, Thermal Protection System eng…
Ver en NASA ↗Engineers and technicians at NASA Glenn's Plum Brook Station in Sandusky, Ohio, are preparing for the first major test in the campaign to verify the structural integrity of Orion’s service module for Artemis I, the spacecraft’s first flight atop the agency’s …
Ver en NASA ↗An active region at the edge of the Sun blew out an X4 flare (one of the largest of the solar cycle) and a coronal mass ejection on Feb. 25, 2014. The still image of the ejected plasma (taken at 00:45 UT) shows it curled like a shrimp, but this eruption was n…
Ver en NASA ↗A twisted blob of solar material – a hot, charged gas called plasma – can be seen erupting off the side of the sun on Sept. 26, 2014. The image is from NASA's Solar Dynamics Observatory, focusing in on ionized Helium at 60,000 degrees C. Credit: NASA/SDO N…
Ver en NASA ↗Engineers and technicians at NASA Glenn's Plum Brook Station in Sandusky, Ohio, are preparing for the first major test in the campaign to verify the structural integrity of Orion’s service module for Artemis I, the spacecraft’s first flight atop the agency’s …
Ver en NASA ↗KENNEDY SPACE CENTER, FLA. -- On Launch Pad 39B, the payload transport canister waits at the base of the Rotating Service Structure (RSS) with the P6 integrated truss segment inside. The canister will be lifted up to the payload changeout room (PCR) where the…
Ver en NASA ↗1st Lt. Ina Park, launch weather officer, 30th Operations Support Squadron, U.S. Air Force participates in a prelaunch news conference on Friday, March 7, 2025, to discuss the upcoming launch of NASA’s SPHEREx (Spectro-Photometer for the History of the Univer…
Ver en NASA ↗KENNEDY SPACE CENTER, Fla. -- Inside the mobile service tower at Launch Complex 17-A, Cape Canaveral Air Force Station, the Genesis spacecraft waits for the first half of the fairing to be installed (behind it). Genesis is 7.5 feet (2.3 meters) long and 6.6 f…
Ver en NASA ↗The Saturn V vehicle, carrying the unmarned orbital workshop for the Skylab-1 mission, lifted off successfully and all systems performed normally. Sixty-three seconds into the flight, engineers in the operation support and control center saw an unexpected tel…
Ver en NASA ↗KENNEDY SPACE CENTER, FLA. -- The payload transport canister, with the P6 integrated truss segment inside, is close to the payload changeout room on the Rotating Service Structure (RSS) at left. The PCR is the enclosed, environmentally controlled portion of t…
Ver en NASA ↗KENNEDY SPACE CENTER, FLA. -- On Launch Pad 39B, the payload transport canister, with the P6 integrated truss segment inside, is lifted higher toward the payload changeout room (PCR) above it. The PCR is the enclosed, environmentally controlled portion of the…
Ver en NASA ↗KENNEDY SPACE CENTER, Fla. -- In the Payload Hazardous Servicing Facility, workers help guide the crane moving Genesis spacecraft toward the upper stage of the Delta rocket at right. Genesis is 7.5 feet (2.3 meters) long and 6.6 feet (2 meters) wide, with a w…
Ver en NASA ↗KENNEDY SPACE CENTER, Fla. -- Inside the mobile service tower at Launch Complex 17-A, Cape Canaveral Air Force Station, the Genesis spacecraft is being encapsulated inside the fairing. Workers check the fittings on the first half. The second half is in the fo…
Ver en NASA ↗KENNEDY SPACE CENTER, Fla. -- The Genesis spacecraft, enclosed in its protective cover, is transported from the Payload Hazardous Servicing Facility on its way to Launch Complex 17-A, Cape Canaveral Air Force Station. Genesis is 7.5 feet (2.3 meters) long and…
Ver en NASA ↗Engineers and technicians at NASA Glenn's Plum Brook Station in Sandusky, Ohio, are preparing for the first major test in the campaign to verify the structural integrity of Orion’s service module for Artemis I, the spacecraft’s first flight atop the agency’s …
Ver en NASA ↗KENNEDY SPACE CENTER, FLA. -- Workers in the Space Station Processing Facility line up on the sides of the payload transport canister as an overhead crane moves the P6 integrated truss segment into position above it. After being placed in the canister, the tr…
Ver en NASA ↗CAPE CANAVERAL, Fla. – On the floor of the Vehicle Assembly Building at NASA's Kennedy Space Center in Florida, workers start removing the plastic wrap from the Ares I-X roll control system module. The system is designed to perform a 90-degree roll after the…
Ver en NASA ↗CAPE CANAVERAL, Fla. – The Ares I-X roll control system module has been placed on the floor of the Vehicle Assembly Building at NASA's Kennedy Space Center in Florida after its arrival. The system is designed to perform a 90-degree roll after the rocket cl…
Ver en NASA ↗MMS Spacecraft Animation The Magnetospheric Multiscale (MMS) mission is a Solar Terrestrial Probes mission comprising four identically instrumented spacecraft that will use Earth's magnetosphere as a laboratory to study the microphysics of three fundamental …
Ver en NASA ↗Contenido y metadatos proporcionados por la NASA Image and Video Library.